Cur amach

Tástáil aonfhoirmeachta teochta ar chiseal pláta triomadóir reo

.

. of each layer. Start the freeze dryer, set the temperature of the heat transfer oil to 3 points of 4{{10}}℃, 0℃and 40℃, respectively. After the inlet and outlet temperatures of the heat transfer oil reach equilibrium at each set temperature point, run for 30 min, and keep at -40 The uniformity of the layer temperature at℃, 0℃and 40℃. Perform 3 replicate tests. After the verification test is completed, the temperature probe will be used for post-calibration. The calibration points are set to 3 points of -40℃, 0℃and 40℃, and the reading deviation of the Ba chóir go mbeadh iar-chalabrú<0.5°C.

. ba chóir go mbeadh sé níos lú ná nó cothrom le 2 chéim, agus tá aonfhoirmeacht an chiseal boird cáilithe .


B’fhéidir gur mhaith leat freisin

Glaoigh Linn